
Registered Design
Titanium Screw Back
The Titanium Screw Back is a Blissed design, registered in our name and engraved with the Blissed monogram. It holds an earring firmly in place and marks every pair as ours.
- Material
- Titanium
- Fastening
- Screw back
- Mark
- Monogram
Designed by us, registered to us
A push back holds by friction, and friction loosens with wear. We drew our own screw back to keep earrings secure, and made it in titanium for its strength and light weight.
Every back is engraved with the Blissed monogram. The design is registered, so its shape belongs to Blissed alone.
How it fastens
- Step 1
Threaded post
The earring post carries a fine thread at its end.
- Step 2
Turn to close
The titanium back turns onto the thread until it rests close to the ear.
- Step 3
Turn to open
To remove the earring, turn the back the other way. It will not slip off on its own.
In detail
- Material
- Titanium
- Engraving
- Blissed monogram
- Status
- Registered design
- Designed by
- Design Creation
- Used on
- Blissed stud earrings
Questions
How do I wear a screw back earring?
Pass the post through, then turn the back clockwise until it sits close to the ear. Turn it anticlockwise to take it off.
Can I buy a spare back?
Yes. Contact our customer care team and we will send a spare titanium back for your pair.
- RJC certifiedMade by Design Creation, a Responsible Jewellery Council certified company.
- 47-point inspectionEvery piece is checked against 47 points before it leaves us.
- Made in SuratDesigned, made and finished in our own workshop in India.